DCP Global
Previous product
Next product
 |
| ||||||||
UsageStrongcoat WD is applied by brush, roller or airless spray (minimum two coats) and has good durability toward pedestrian and vehicular traffic. It is also resistant to many of the chemicals commonly found in an industrial environment (consult Technical for further details). It can be supplied in a variety of colours (consult our Sales Department for details). Slip resistant finishes can be produced for very demanding situations. Kit form5Kg and 10Kg Specified Coating ThicknessApproximately 100 microns/coat. CoverageStore at temperatures between 5° C and 30° C Shelf LifeApproximately 12 months if stored in unopened containers and under good conditions. |
Technical Information
ApplicationSURFACE PREPARATION The surface must be clean, dry (less than 75% RH measured by hygrometer) and free from dust, laitance, oils, paints or other forms of contamination. Grit blasting can be used to remove laitance and surface contamination (see DCP Guide to Surface Preparation for further details). For treatment of surfaces containing expansion joints consult our Technical Department. MIXING Taking care to ensure that the bottom and sides are thoroughly scraped, transfer the entire contents of the Strongcoat WD Hardener and Strongcoat WD Resin container into a mixing bucket and, using a jiffy-type mixer attached to a slow-running electric drill, mix for approximately two minutes. Never mix Strongcoat WD by hand as this could lead to areas of uncured material. APPLICATION Once mixing is complete, transfer the Strongcoat WD to a roller tray and, using a medium-pile simulated sheepskin roller, apply it evenly over the surface. WORKING TIME Strongcoat WD has a working time of approximately 20 minutes at 20°C. Never leave the mixed Strongcoat WD kit to stand for any length of time prior to application as this will considerably shorten its working time. |
Download file
