DCP Global
Previous product
Next product
 |
| ||||||||||||||||||||||||||||||||
UsageGripdeck
Wearcoat Plus is primarily designed for use in car parks and offers
excellent chemical resistance against petrol, battery acids, diesel,
brake fluids, de-icing salts, etc. Other applications include showrooms, retail, car dealerships etc. Gripdeck Wearcoat Plus is specifically formulated for colour stability. It will not discolour on exposure to sunlight or other sources of UV light. Materials Supplied15kg pack sizes comprising resin base and hardener components StorageStore under dry warehouse conditions at a temperature between 10°C and 30°C. Shelf Life12 months in an unopened undamaged, sealed containers and stored under good conditions. CoverageThe coverage obtained will vary depending on the type and size of Aggregate used. As a guide, the coverage should be a minimum of 0.8Kg per m² on a Quartz Aggregate blind, 1.2Kg per m² on a Gripdeck Aggregate blind, 0.3kg/m² on to smooth Strongcoat Primer. |
Technical Information
* (do not apply if the ambient or floor temperature is to fall below 10°C during the first 24 hours) ** Gripdeck Medium Aggregate blind Application InstructionsMIXING Gripdeck
Wearcoat Plus comprises two components, a Resin Base and Hardener
which are supplied pre-weighed in the correct proportions. Under no
circumstances should part mixing be carried out. Taking care to ensure that the bottom and sides are thoroughly scraped, transfer the entire contents of both components into a separate mixing container. Using a power whisk attached to a slow speed electric drill, mix for approximately 3 minutes ensuring the mixing head is pushed around the sides and bottom of the mixing container. Transfer the contents into another container, scraping down and re-mixing for a further 2 minutes avoiding the entraining of excessive air until a uniform consistency is obtained. Important:
Never mix Gripdeck Wearcoat Plus by hand as this could lead to areas of
uncured material. Premixing of the resin component will aid mixing. PRIMING (Car Parks) Use Gripdeck Primecoat or Strongcoat DPM (please see appropriate product data sheets for more information). PRIMING (Non Car Parks) Sufaces must be primed with Strongcoat Primer. If the substrate humidity reading is greater than 75% it is recommended that Strongcoat DPM be used prior to primimg with Strongcoat Primer (please consult appropriate data sheets). APPLICATION OVER AGGREGATE On completion of mixing immediately apply the Gripdeck Wearcoat Plus by squeegee followed by a short / medium pile roller at the required rate onto the pre-swept blinded surface. APPLICATION ON TO A PRIMED BASE Once mixing is complete transfer the Gripdeck Wearcoat Plus to a roller tray, and using a medium pile simulated sheepskin roller, apply it evenly over the surface. CLEANINGTools should be cleaned with suitable solvent immediately after use. HEALTH & SAFETY Consult the appropriate Material Safety Data Sheet before using Gripdeck Wearcoat Plus. GENERAL GUIDANCE This data sheet is for general guidance purposes only and may contain information that is inappropriate for certain conditions of use. Accordingly, all recommendations and suggestions are made without guarantee. Further information is available from our Technical Department. |
Download file
