Proplast Universal Primer is an ideally designed primer coat to increase the bonding on smooth concrete substrates for DCP full range of decorative platers.
Proplast Universal Primer can be used internally, externally and for vertical and overhead applications.
Proplast Universal Primer is available in 18 litre plastic buckets.
Approximately: 5 - 8 m2/ 1 ltr.
Single coat wet film thickness is estimated at 200 microns.
Dry film thickness will be between 55 - 90 microns.
Store in a shaded place at a
temperature of 25°C in original unopened packaging .
Proplast Universal Primer has a shelf life of 12 months from date of manufacture.
The technical data are specified at 23 ° C.
Substrate must be clean and free from oil, grease, dust and laitance. Surface laitance should be removed by light scabbling or grit blasting.
Proplast Universal Primer does not require dilution. Mix continuously with low speed mixer/drill (400 - 600 rpm) for 3 - 5 minutes. Make sure the contents are stirred well before use.
Proplast Universal Primer is applied with a textured roller to the prepared substrate making sure to obtain 100% coverage.
Decorative Plaster should be applied 24 hours after Proplast Universal Primer dries.
All tools should be cleaned immediately after finishing using clean water.
HEALTH & SAFETY
Proplast Universal Primer should not be swallowed. Gloves and eye protection should be worn.
In case of accidental contact with eyes, immediately flush with plenty of water for at least 10 minutes and seek medical advise if necessary.
Proplast Universal Primer is nonflammable.